Wednesday, February 8, 2012
Thursday, February 2, 2012
Step by Step Replace your toilet.
This is one of the easiest projects you can do that will save you $100-$200 in labor. Replacing your toilet is easy. Below are the steps. Thank you to the DIY Network!
Step 1: Empty the Tank
Turn off the water at the toilet stop by turning the handle clockwise. Drain the tank by pulling on the handle. Take a sponge and bucket to soak up the remainder of water left in the tank. If needed, use some paper towels to finish the job.
Now that the tank is empty, it's time to address the bowl. Since there's still water left in the trap, take an ordinary plunger and press it once or twice as you would with a clogged toilet. This will force all the water out of the trap making the old toilet ready for removal.
Step 2: Disconnect the Tank
The first step in actually disconnecting the toilet from the bathroom is to unscrew the supply line from the stop using a crescent wrench.
Next, disconnect the tank to bowl nuts on the tank. Simply use a long screwdriver to hold them in the tank and then loosen them from the underside. Now the tank is free from the bowl and can be easily lifted.
Step 3: Remove the Bowl
Flip up the bolt covers and remove them if necessary. Loosen the bolts slightly, but make sure they don't start to spin.
Now that the closet bolts are disconnected, tightly grip the old toilet and lift it out.
Step 4: Replace the Wax Ring
The next step is to take an ordinary putty knife and scrape off the old wax ring (Image 1).
Place a new wax ring over the flange (Image 2).
Step 5: Create a Seal
Line up the closet bolts with the bowl and gently let down the bowl.
To make sure a proper seal is created with the flange and drain, temporarily add the seat and sit on the toilet. The added weight will evenly press the seal tight.
Tighten the provided nuts over the closet bolts and tighten.
Step 6: Align the Flushing Valve
Line up the flushing valve to the opening in the top of the toilet bowl. After making sure the seal is in place, add the tank to bowl gaskets. Secure the tank with a screwdriver and crescent wrench.
Step 7: Finish the Installation
New stainless steel supply lines from the ballcock to the stop should be installed.
Next, open up the valve to let the tank fill about 1/4 of the way full. Now, check for leaks.
Add the toilet seat and bolts; adjust the float slider if necessary.
Subscribe to:
Posts (Atom)